WANHAO Duplicator 4x Manuel d'utilisateur télécharger pdf (Page 27)

LEVELING THE BUILD PLATE

--------------------------------------------------------------------------------------------------------------------------------------------

3. Press the OK to Begin Heating the Extruder

4. Press the ＂ＯＫ＂　to Continue

After the extruder reaches 220° C, the

LCD panel will prompt you to load the

PLA Filament into the extruder. Click

through the message until your Printer

asks you to press the OK when you see

plastic extruding.

After you’ve fed the PLA Filament

all the way through the guide tube,

press the OK button on the LCD menu.

The Duplicator will start to heat your

extruder.

WARNING: Do not touch the extruder

while it is heating — it heats to 220° C.

Press the ok

Startup process: leveling, loading , testing 26

------------------------------------------------------------------------------------------------------------------------------------------

--------

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 72 73

Pas de commentaire

WANHAO Duplicator 4x Manuel d'utilisateur Page 27